Washers for Z1 SL-14
An additional set of washers is needed to correctly install the new skylight lens on a current Z1 helmet.
Bolts for Z1 SL-14
These are the current bolts for the Z1 that will work with both the traditional visor surround and the new skylight lens (includes extra washer set). Includes 2 complete bolts and installation instructions.
Z1 HP Lens Clear
This is the original clear Z1 lens that installs into the framed visor. It has a scratch-resistant finish on the outside and a fog-resistant finish on the inside.
Z1 HP Lens Smoke Tint
This is the original smoke tint Z1 lens that installs into the framed visor. It has a scratch-resistant finish on the outside and a fog-resistant finish on the inside.
Skylight Lens Only
Shatterproof 2.5mm polycarbonate Skylight lens. If you have an existing Z1 with the current bolt system, you will need to order an additional set of Skylight washers to install this properly.
Ratchet Chin Cup Kit
The Ratchet Chin Cup for open-face helmets is adjustable from both sides and quick to release with one hand, this lends stability if you are adding a camera to your open-face helmet. The kit requires a household drill to remove existing chinstrap-- easy to install. Also available now is a chin cup with a cutaway system. See the Quick Release Kit.
Skylight Lens Kit
The kit includes the shatterproof 2.5mm polycarbonate Skylight lens, bolt set, logo, and installation instructions. This kit may be installed on your current Z1 helmet.
Quick Release Kit with Strap & Cup
Install this kit to make an open-face helmet cutaway simple and clean. The handle is easy to locate but not so easy to snag. There is a small amount of installation required-- you will need to replace the chinstrap with the chin cup on your open-face helmet (can be done with a household drill).